choose a water-type mold temperature controller when your mold runs at about 120°C or below (up to 160–180°C with pressurized high-temperature water) — water heats and cools faster, is cheap and clean, and suits most general injection molding. Choose an oil-type unit when the process needs sustained temperatures above roughly 120–150°C, commonly up to 200°C and as high as 300°C, because thermal oil delivers high temperature at low pressure without scale or corrosion. This guide compares the two on the factors that actually drive the decision.
We are thrilled to announce that SUZHOU LESINTOR, a leading Chinese manufacturer of high-performance plastic auxiliary equipment, will be exhibiting at the prestigious PLASTICS & RUBBER INDONESIA 2025. We extend a warm invitation to all our valued customers, distributors, and industry partners in Southeast Asia to visit us and discover solutions that enhance your productivity.